The SSDC10 StepSERVODrives are the closed-loop versions of our well established, high performance, microstepping step motor drives. By incorporating closed-loop servo control algorithms in these drives and pairing them with StepSERVOMotors with high resolution encoders, we are able to create StepSERVOsystems with performance that greatly exceeds conventional step motor performance. Peak torques as much as 50% higher; smoother, quieter operation; and lower power consumption are just some of the benefits of StepSERVODrive and Motor systems.
El SSDC10 puede alimentarse con tensiones de alimentación comprendidas entre 24 y 70 VCC, con una tensión de alimentación recomendada de 48 VCC.
The SSDC10 can be powered by supply voltages in the range 24 to 70 VDC, with a recommended supply voltage of 48 VDC. See Related and Recommended Products below for compatible power supplies.
StepSERVODrives are compatible only with StepSERVOMotors from Applied Motion.
Each SSDC drive comes with 8 digital inputs, 4 digital outputs, and 2 analog inputs. The digital inputs accept signals of 5-24 VDC and can be used for connecting end-of-travel limit switches, PLC outputs, sensors and other signal types. The digital outputs can be connected to PLC inputs, counters, lights, relays and other devices. The 2 analog inputs accept 0-5, 0-10, ±5 or ±10 volt signals, and can be used as an additional sensor input. Differential encoder signal outputs are also available from the drive. For the model SSDC10-IP there are the following:
- Dual fast 10/100 Mbit Ethernet ports for configuration, programming and daisy chain networking connections.
- Designed for use on EtherNet/IP networks, the widely used industrial protocol for manufacturing automation applications.
- Stream commands from a host controller to multiple axes using Applied Motion's Serial Command Language (SCL) over Ethernet. Supports both TCP and UDP protocols.
- Built-in support for Modbus TCP communications.
