Specifications |
System |
CPU |
32-bit MCU |
Dual Watchdog |
Yes |
Communication
|
Ethernet Port |
10/100 Base-TX, 8-Pin RJ-45 x1, (Auto-negotiating, Auto-MDI/MDIX, LED indicator) |
PoE (IEEE 802.3af, Class 1) |
LED Display
|
S1 |
PoE indicator (Green) |
Run indicator (Red) |
E1 |
Link/Act indicator (Green) |
10/100 M indicator (Yellow) |
Mechanical
|
Dimensions |
52 mm x 27 mm x 98 mm |
Installation |
DIN-Rail mounting |
Environment
|
Operating Temperature |
-25°C ~ +75°C |
Storage Temperature |
-30°C ~ +80°C |
Humidity |
10 ~ 90 % RH, non-condensing |
Power Requirements
|
Power Input |
PoE: IEEE 802.3af, Class 1 |
Terminal block: +12 ~ 48 VDC (non-regulated) |
Power Consumption |
0.03 A @ 48 VDC for tPET-P2R2 |
I/O Specifications |
Digital Input
|
Input Channels |
2 |
Input Type (Device) |
Wet Contact (Sink, Source) |
On Voltage Level |
+10 VDC ~ +50 VDC |
Off Voltage Level |
+4 VDC max. |
Input Impedance |
10 k Ohm |
Counters |
Max. Count: 4,294,967,285 (32 bits) |
Max. Input Frequency: 3.5 kHz (without filter) |
Min. Pulse Width: 0.15 ms |
Frequency Measurement |
1 ~ 3.5 kHz in Mode "1000 ms", (+/- 1 Hz error) |
10 ~ 3.5 kHz in Mode "100 ms", (+/- 10 Hz error) |
0.01 ~ 1 Hz in Mode "Single-pulse", (+/- 0.01 Hz error) |
Over-Voltage Protection |
+70 VDC |
Isolation |
3750 Vrms |
Relay Output
|
Output Channels |
2 |
Output Type (module) |
Power Relay, Form A (SPST N.O.) |
Load Voltage |
- |
Load Current |
- |
- |
- |
Turn ON Time |
- |
Turn Off Time |
- |
Output Isolation |
3000 Vrms |
Output Voltage Range |
250 VAC/30 VDC |
Max. Load Current |
5.0 A/channel at 25 °C |
Operate Time |
6 ms |
Release Time |
3 ms |
PWM |
100Hz max |
The unit of duty cycle is 1 ms, and the resolution is about 5 ms.(5~65535 ms) |
Electrical Life (Resistive load) |
VED |
5 A 250 VAC 30,000 ops (10 ops/minute) at 75 °C |
5 A 30 VDC 70,000 ops (10 ops/minute) at 75 °C |
UL |
5 A 250 VAC/30 VDC 6,000 ops |
3 A 250 VAC/30 VDC 100,000 ops |
Mechanical Life |
20,000,000 ops. At no load (300 ops./minute) |
Note: Because the characteristic of relay, PETL-706X series (the module with relay) are not suitable to use PWM for a long time.
|