Z-4TC

Z-4TC is an interface for Thermocouple sensors (J, K, E, N, S, R, B ,T) and generic sensor with mV as standard output signal. The number of input is 4 and each input is independent from each other. It’s a ModBUS Slave and can be coupled with any ModBUS Master device. A 3-way galvanic isolation among Power supply // input // RS485 circuits assures the integrity of your datas.

• Internal Cold Junction compensation
• Easy configurable by free configuration software”Easy Setup”
• RS485 serial communication with MODBUS-RTU protocol, maximum 32 nodes.
• RS232serial communication with Modbus RTU protocolfor registers access and configuration
• Measuring mode Thermocouples or Voltage
• Configuration ofa filter applied to each input signal
• Possibility to disable the automatic detection of thermocouple interruptions (to decrease the measure error of the acquired signals from the thermocouples)
• Possibility to add/remove the module to/from RS485-bus without disconnecting the communication or power supply
• Easy-wiring of power supply and serial bus by means of the bus housed in the DIN rail.

Data Sheet