| Specifications |
| SUPPLY VOLTAGE | 10 to 30 VDC on 4-20mA and 0-5 VDC models
15 to 30 VDC for 0-10 VDC models
Polarity Protected |
| CURRENT REQUIREMENTS | UVS-1A through 4A; 50 mA max
UVS-5A & 6A; 65 mA max (exclusive of load) |
| DIGITAL OUTPUT | (1) NPN and (1) PNP output transistor:
NPN: Sink up to 150 mA
PNP: Source up to 150 mA
Continuous short circuit protected
Outputs protected from pulsing during power up |
| ANALOG OUTPUT | • 4 – 20 mA; 0-5 VDC; or 0-10 VDC |
| RESPONSE TIME | 200us for UVS-1A through 4A
750µs for UVS-5A
300µs for UVS-6A |
| AMBIENT TEMPERATURE | -15°C to +70°C (5°F to 158°F) |
| LIGHT IMMUNITY | Responds to sensor’s pulse modulated light source, resulting in high immunity to most ambient light, including indirect sunlight |
| CONNECTION TYPE | Built in 6" pigtail cable with 5-Pin Male, M12 Mini Micro connector |
| PUSHBUTTON CONTROL | AUTOSET pushbutton setup
Tweak adjustments with “UP” or “DWN” buttons
Selection of Light/Dark operation
Enable/Disable pulse stretcher
"Select" button scrolls thru four AUTOSET modes |
| DIAGNOSTIC INDICATORS | Contrast Indicator – Display scaled reading of sensor’s response to contrasting UV light levels (light vs. dark) on an 8 bar LED display Note: All 8 LEDs will flash three times if contrast insufficient or too low in Two-Point AUTOSET mode
Red LED Output Indicator – Illuminates when the sensor’s output transistors are “ON” NOTE: If Output LED flashes, a short circuit condition exists
Green LED Timer Indicator – Illuminates when the 15 ms pulse stretcher timer is enabled |
| LIGHT SOURCE | UV LED, 375 nm Wavelength |
| RUGGED CONSTRUCTION | Chemical resistant high impact polycarbonate housing, acrylic or glass lens cover
Industry Ratings: NEMA 4, IP67 |
| CERTIFICATIONS | UL, CE, RoHS |
