| Specifications |
| Model Specific |
| Adjustment Type | Potentiometer |
| Connection Type | Connector, 4-pin M12 |
| Housing Type | Rectangular |
| Optical Block | Type V1, Focused Lens "V" Axis Direct lens “V” axis sensing at close ranges. Used for small part or precise leading edge sensing. |
| LED Light Source | White=Broadband Color Spectrum The “White Light” LED light source promotes easy detection of the largest variety of color marks printed on the largest variety of colored web materials. By combining a white LED light source, our Contrast Indicator, and the one-push AUTOSET setup, you have a winning combination of high performance with an easy to use sensor. |
| Sensing Range | 2in |
| Family Specific |
| Supply Voltage | 12 to 24 VDC Polarity Protected |
| Current Requirements | 85mA (exclusive of load) |
| Output Transistors | (1) NPN and (1) PNP sensor output transistor NPN Sink up to 150mA PNP Source up to 150mA Momentary short circuit protected Outputs protected from pulsing during power up Light/dark switch de4termines output status Light=Light "ON" operate Dark=Dark "ON" operate |
| Response Time | Minimum duration of input event Light state response=50 microseconds Dark state response=140 microseconds Leading edge variation less than 20 microseconds |
| Hysteresis | Less than 400 millivolts for maximum sensitivity and resolution |
| Indicators | - OUTPUT INDICATOR: Red LED illuminates and the NPN or PNP outputs switch to the opposite state when retunred light level exceed "5" on the CONTRAST INDICATOR
- EDR® INDICATOR - Intensity of GREEN LED provides indication of where in the dynamic operating range the offset, EDR® adjustment has been set
- FULLY LlT: Operating near saturation
- OFF: Operating near maximum sensing range
- CONTRAST INDICATOR – Displays scaled reading of sensor's response to contrasting light levels (light vs. dark) on a ten bar LED display
|
| Light Immunity | Responds to sensor’s pulse modulated light source, resulting in high immunity to most ambient light, including high intensity strobes |
| Ambient Temperature | -40°C to 70°C (-40°F to158°F) |
| Rugged Construction | Chemical resistant, high-impact polycarbonate housing Waterproof, NEMA 4X, 6P and IP67 enclosure ratings Epoxy encapsulated for mechanical strength |