S311D-11-L

S311D-11-L is an indicator totalizer that accetpts universal opto isolated digital input. Admitted signal types are reed, npn (2 wires or 24 V), pnp (24 V), NAMUR, photoelectric, Hall, 24 V input, TTL, variable reluctance. Digital input signal frequency measurement starts from 0.00015 Hz to 10 kHz. S311D supports increment or decrement totalizing of the digital input signal. Also it's possibile viewing the frequency measurement and/or totalized value. Programmable retransmission of the input value frequency is possibile by the isolated analog output (voltage or active/passive current). Retransmission of the totalized value by the isolated digital output (Open Collector). Totalizer value is saved on non-volatile memory.

• Universal opto isolated digital input; admitted types: reed, npn (2 wires or 24 V), pnp (24 V), NAMUR, photoelectric, Hall, 24 V input, TTL, variable Digital input signal frequency measurement from 0.00015 Hz to 10 kHz.
• Increment or decrement totalizing of the digital input signal.
• View of the frequency measurement and/or totalized value.
• Programmable retransmission of the input value frequency by the analog output isolated (voltage or active/passive current).
• Retransmission of the totalized value by the digital output (Open Collector). isolated
• Totalizer value is saved on non-volatile memory.
• Filter programmable at 20 levels to stabilise reading.
• Totalizer reset by auxiliary digital input, buttons pressure or Modbus register.
• 4, 6, 8 or 11 (4+7) Digits display.
• In case of optional card use, two relay alarms are activable on the input measurement frequency (maximum, minimum, automatically resettable or not) or on the input treshold values of totalizer (not automatically resettable).
• Alarms status visible through two leds on the frontal panel.
• RS485 serial communication with MODBUS RTU protocol (by optional board), maximum 32 nodes.
• Two relay outputs (available on the optional card) for alarms signalling.
• Easy navigation on the programming Menu by three buttons on the frontal panel.
• Quick configuration of the alarm thresholds by the Quick Alarms Menu
• Display contrast adjustable.
• Easy Setup configuration Software.
• Very Low Frequency Mode (VLF) automatically set if fmax 1 Hz.