| SPECIFICATIONS |
| TECHNICAL DATA |
| SUPPLY VOLTAGE | 10 to 24 VDC
Polarity Protected |
| CURRENT REQUIREMENTS | 50mA (exclusive of load) |
| OUTPUT TRANSISTORS | (1) NPN and (1) PNP sensor output transistor
Sensor outputs can sink or source up to 150mA (current limited)
All outputs are continuously short circuit protected |
| RESPONSE TIME | Light/Dark state response = 500 microseconds |
| LED LIGHT SOURCE | Infrared = 880nm, Red = 660nm, Pulse modulated |
| PUSH-BUTTON CONTROL AUTOSET | Routine: Push and release with sensor in light state.
Excess Gain Adjustment: Tap Twice to step to higher excess gain.
Push and hold to activate Flash Rate Alignment Indicator.
Light/Dark ON selection: Tap 5 times to toggle.
RANGE Dependent on optical block |
| HYSTERESIS | Approximately 15% of signal |
| LIGHT IMMUNITY | Responds to sensor’s pulsed modulated light source, resulting in high immunity to most ambient light, including indirect sunlight or strobes |
| DIAGNOSTIC INDICATORS | Dual Red/Green LED
Red = Output Status NOTE: If Output LED flashes a short circuit condition exists.
Green = Flash Rate Alignment Indicator.
Dual Green/Amber LED
Green = ON After AUTOSET Routine
Amber = ON After Excess Gain Adjustment |
| AMBIENT TEMPERATURE | -40°C to 70°C (-40°F to 158°F) |
| RUGGED CONSTRUCTION | Chemical resistant, high impact polycarbonate housing
Waterproof ratings: NEMA 4, and IP67
Conforms to heavy industry grade CE requirements |
