PISO-CAN100U-D

The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN100U-D/T can represent an economic solution of an active CAN board. It has one CAN bus communication port with 5-pin screw terminal connector or 9-pin D-sub connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN100U-D/T uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.

• One CAN bus communication port
• Compatible with CAN specification 2.0 parts A and B
• On-board optical isolation protection
• Programmable transfer rate up to 1 Mbps
• 2500 Vrms photo couple isolation on the CAN bus
• Jumper select 120O terminal resistor for each port
• Direct memory mapping to the CAN controllers
• 33MHz 32bit 5V PCI bus (V2.1) plug and play
• Universal PCI card, supports both 5V and 3.3V PCI bus