| Technical Features
|
| Model Specific
|
| Adjustment Type: |
Potentiometer |
| Connection Type: |
Connector, 4-pin M8 |
| Housing Type: |
18MM |
| Output Transistors: |
- NPN: Sink up to 100mA
- All outputs are continuously short circuit protected
|
| Supply Voltage: |
- 10 to 30 VDC
- Polarity Protected
|
| LED Light Source |
Infrared = 880nm
Best choice in most opaque object sensing tasks. Provides longest possible sensing range in either
Beam Make or Beam Break sensing modes. Best choice in hostile environments; useful in penetrating
lens contamination. Preferred for use with small glass fiberoptic light guides Note: Do not use IR
light with plastic fiberoptic light guides. Preferred when sensing dark colored objects in the
proximity (Beam Make) mode, i.e., black, blue, green, etc. Useful in penetrating containers for
verification of contents; also useful in detecting overlapped splices in dense materials. Color
perception; tends to favor blue colored objects. |
| Sensing Range: |
|
| Family Specific |
| Current Requirements: |
30mA (exclusive of load) |
| Remote AUTOSET Input: |
Opto-isolated momentary sinking input (10 milliamps) |
| Response Time |
- Light State response = 600µs (1,100µs, Thru-Beam)
- Dark State response = 600µs (1,100µs, Thru-Beam)
|
| Light/Dark "ON" Operation: |
- Light “ON” achieved by connecting white wire to negative lead
- Dark “ON” achieved by connecting white wire to positive lead
|
| Range: |
Dependent on model, see Selection Guidelines Note: 5 VDC models, range reduced by
10% |
| Hysteresis: |
Approximately 20% of signal |
| Light Immunity: |
Responds to sensor’s pulse modulated light source, resulting in high immunity to most ambient light,
including high intensity strobes |
| Diagnostic Indicators: |
- Red LED = Output Status
- Green LED = Power “ON”
|
| Ambient Temperature: |
-40°C to 70°C (-40°F to 158°F) |
| Rugged Construction: |
- Chemical resistant, high-impact polycarbonate housing
- Waterproof ratings: NEMA 4X, IP66
|
