Specifications |
CAN Interface |
Controller |
Microprocessor inside with 20MHz |
Transceiver |
NXP 82C250 |
AMIS 41682 |
1 |
Connector |
9-pin male D-Sub (CAN_L, CAN_H, N/A for others) |
Baud Rate (bps) |
10 k, 20 k, 50 k, 100 k, 125 k, 250 k, 500 k, 800 k and 1 Mbps |
Protection |
3000 VDC power protection on CAN side, 2500Vrms photo-couple isolation on CANbus |
Terminator Resistor |
Selectable 120 ? terminator resistor by jumper |
Support Protocol |
CAN 2.0A/2.0B |
Receive Buffer |
1000 data frames |
UART Interface |
COM |
RS-232 |
Connector |
14-pin terminal connector RS-232 : TxD, RxD, GND RS-422 : Tx+, Tx-, Rx+, Rx RS-485: D+, D |
Baud Rate (bps) |
110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps |
Data bit |
5, 6, 7, 8 |
Stop bit |
1, 2 |
Parity |
None, Even, Odd |
Receive Buffer |
900 data frames |
LED |
Round LED |
ON LED: Power and Data Flow; ERR LED: Error |
Power |
Power Requirement |
Unregulated +10VDC ~ +30VDC. Power reverse protection, Over-Voltage brown-out protection |
Power Consumption |
1 W |
Mechanism |
Installation |
DIN-Rail |
Dimensions |
72mm x 118mm x 33mm (W x L x H) |
Environment |
Operating Temp. |
-25 ~ 75° C |
Storage Temp. |
-30 ~ 80° C |
Humidity |
10 ~ 90% RH, non-condensing |