Specifications |
CAN Interface |
Controller |
Microprocessor inside with 96 MHz |
Transceiver |
NXP 82C250 |
AMIS 41682 |
1 |
Connector |
9-pin male D-Sub (CAN_L, CAN_H, N/A for others) |
Baud Rate (bps) |
10 k, 20 k, 50 k, 100 k, 125 k, 250 k, 500 k, 800 k and 1 M (allow user-defined baud rate) |
Protection |
3000VDC power protection and 3750Vrms photo-couple isolation on CAN side |
Terminator Resistor |
Selectable 120 ? terminator resistor by jumper |
Support Protocol |
ISO-11898-2, CAN 2.0A and CAN 2.0B |
Pin Assignment |
C.I.A. DS-102 (CAN_H=7, CAN_L=2) |
UART Interface |
COM |
RS-232: TxD, RxD, GND; RS-422: TxD+, TxD-, RxD+, RxD-; RS-485: DATA+, DATA |
Connector |
14-pin terminal connector |
Baud Rate (bps) |
300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400 |
Protection |
3000VDC power protection and 2500Vrms photo-couple isolation on UART side |
LED |
Round LED |
PWR / CAN / UART |
Power |
Power supply |
+10 ~ +30 VDC |
Power Consumption |
1.5W |
Dip Switch |
Init (Firmware Update, Module Configuration)/Normal (Firmware Operation) |
Mechanism |
Installation |
DIN-Rail |
Dimensions |
72mm x 118mm x 33mm (W x L x H) |
Environment |
Operating Temp. |
-25 ~ 75° C |
Storage Temp. |
-30 ~ 80° C |
Humidity |
10 ~ 90% RH, non-condensing |