Specifications |
Hardware |
J1939 Port Channels |
1 |
CAN Interface |
Controller |
Microprocessor inside with 96 MHz |
Transceiver |
NXP 82C250 |
Connector |
9-pin D-sub connector |
Baud Rate (bps) |
250k |
Isolation |
3000 VDC power protection on CAN side, 2500Vrms photo-couple isolation on CAN bus |
Terminator Resistor |
Selectable 120? terminator resistor by jumper |
Specification |
ISO-11898-2, CAN 2.0A and CAN 2.0B |
Pin Assignment |
C.I.A. DS-102 (CAN_H=7, CAN_L=2) |
UART Interface |
Connector |
14-pin screw terminal connecter |
COM1 |
RS-232(TXD, RXD, GND) / RS-422(Tx+, Tx-, Rx+, Rx-) / RS-485(D+, D-) |
Baud Rate (bps) |
2400, 4800, 9600, 19200, 38400, 57600, 115200 |
LED |
Round LED |
PWR / J1939 / MODBUS |
Power |
Power supply |
+10 ~ +30 VDC |
Power Consumption |
1.5W |
Dip Switch |
Init (Firmware Update) / Normal (Firmware Operation) |
Mechanism |
Installation |
DIN-Rail |
Dimensions |
108mm x 72mm x 35mm (H x W x D) |
Environment |
Operating Temp. |
-25 ~ 75° C |
Storage Temp. |
-30 ~ 80° C |
Humidity |
10 ~ 90% RH, non-condensing |